Lowering 40mm

[valley_shark]

want to lower my car 40mm 1.1 saxo 1996 but also want to get some 15" 3 sud alloys how much does it cost to have the back arches cut? or will they all need cutting? thanks alot :y:

[Ben_L]

basically its the lip on the arch. if you put your hand under you will feel the plastic strip then a metal bit sticking out. its that metal bit that will be the issue. Depends who you know mate. I wouldn't pay more than £40. I've had mine done think it was about £35. You can roll or cut them, You need it done properly though as the paint will crack if not done properly then rust will get in...

[valley_shark]

is that for all the arches or just the back ones?

[Ben_L]

its just the back ones you need to have done

EDIT: apparently alo you dont always need them doing. it'll only be the drivers side that will rub as the axles are slightly offset

hope this helps bud

[valley_shark]

thanks mate better off having them both dont though just incase. but thanks alot all i need to find now is someone to lower my car and cut the arches but first of all need the money hehe but once all done should look alot better :y: thanks bud :y: