Pi....."innit"

[Morgan_VTR]

Hey guys, just a quick question.

Looking at some Pi springs at the moment... drop for 35mm http://www.pi-suspension.co.uk/p1253153.htm:

Now as the S engine is heavier than the R one, what sort of drop would I be looking at on a MK2 VTR?

Also, on that page is says something about:

1) Bumpstops - do I need them? seen some powerflex one sfor 20 quid on egay

2)MK2 s will require power steering feed pipe relocation - I take the garage would do this if I brought to there attention?

Please no PI are wank or whatever, Im on a budget :)

Quick responses appreciated :y:

[Saxo_Steve]

There won't be a big difference between the S and R, but to get an accurate answer you'll need to tell us what drop the springs state they are.

1) I didn't use these when fitting my lowering kit so as far as I know they're not needed.

2) Yes, the pipe can be relocated or you can just have it bent upwards a bit so that it clears the steering arm.

[Morgan_VTR]

Doh! What a numpty.

There you are mate post edited.

they are 35mm. Ideally would want 35-40 spot on.

[Coonper]

To be honest mate, i wouldnt bother with PI.

[Morgan_VTR]

Please no PI are wank or whatever, Im on a budget :)



To be honest mate, i wouldnt bother with PI.

:clapping:


Unless you want to pay for my springs? I would appreciate it!

[Gabbastard]

I had Pi Saxo springs on my AX, and they were pretty good if a tad hard. On a Saxo they might not be too bad. *shrugs*

[Morgan_VTR]

Lol, cheers mate :)

You got any idea on the drop Id get from those springs on a mk2 VTR?

I mean it says 25 - 50mm....... bit of a big range!