Chaniging MK1 spoiler with into MK2

[LSOfreak]

Is is possible to replace a mk1 spoiler with a mk2, or would i need to buy the whole mk2 bootlid becuase of the holes in the glass apparently?

[tif992ss]

if the mk1 spoiler was fitted at the factory the you are going to be left with two holes in the top of the boot when you remove it , you can stick the mk2 spoiler on with stickaflex/ tiger bond
best bet would be swap the whole hatch and sell your mk1 spoiler to recoup some money
Aid

[LSOfreak]

ah k thanks, if i were to take off the mk1 spoiler, could the holes be filled with something like a grommit or will that just look crap

[s3tre2003]

ah k thanks, if i were to take off the mk1 spoiler, could the holes be filled with something like a grommit or will that just look crap

probs look a bit gash to be honest mate

[LSOfreak]

correct me if im wrong but it will leave slight dents on each side of the boot where the mk1 spoiler was if i took it off wouldnt it?

[LSOfreak]

And also will a mk2 bootlid fit a mk1 saxo and the other way round?

[pjsaunders06]

yes it will the back end are the same on both :y:

[LSOfreak]

Any one no if removing the mk1 spoiler will leave dents and can the holes(and dents if there is any) be sorted out?

[Ge0_Ge]

it shouldnt leave any dents.. just the two holes if it was fitted in factory.. if its glued ur fucked lol...

a mk2 rear would look alot smoother :)

[pjsaunders06]

i have a mk 2 spoiler ready to go on, luckily i dont have a mk 1 spoiler fitted :y: lmao

[LSOfreak]

And how you getting that on, bit of tiger seal?