Lowering!

[saxonat]

Hi i have my car lowered 60mm at front but duno how low to go on the back

anyone n e ideas? :y:

[jazzsingh51]

60mm - and that would be quite low. Make sure you get uprated dampers too

[saxo_bigbass]

100 on rear

[Sean]

100 on rear

60mm on the front with 100mm at the rear? That would be ridiculous not to mention bloody dangerous with it sitting in the bumpstops and putting all the weight on the rear of the car:S

If done properly you can get it to match the back, just do it by sight. The rear is slightly higher than the front though.

[edd]

2 notches on the back. that should do ya

[jazzsingh51]

2 notches on the back. that should do ya

Do NOT lower it by notches - its not the right method and it puts extra strain on the rear suspension components.

Take out the torsion bars, adjust the hub to the correct measured height and re-insert the torsion bars - most decent garages know that this is the correct methos to lower a car with a Torsion bar!

[ollyh]

95mm looks the f-ing tits check out brooksy22's vts

[Hopcraft]

DONT GO NO MORE THAN 70MM on the back imo, and DONT DO NOTCHES as said and DONT GUESS because you wont get the otherside the same.

Why do people suggest such stupid and dangerous things !?!?

Go to a garage and get it done properly, or if your confident look for the badger motorsport guide on here and give it a bash yourself.

BAD suggestions should get bad rep tbh. but i wont ;)