door pins on vtr

[badasssaxo]

Hi, i have removed my door pins from my vtr and i would like some advice on what i could fill the holes with and keep it looking good of course.

[Pieface]

Get Door Pins? or you could always fill it up with something, such as fibreglass?

[tif992ss]

Halfrauds for a couple of rubber blanking grommets
Job done

[badasssaxo]

I Removed Door Pins For Added Security To Stop Little Scrotums Breaking In

[stevo67]

Or you could wire in some flashing leds u can buy them on ebay.

Steve.

[badasssaxo]

Thanks Boys I Will Look Into Some Of These Ideas.

[mcchriswood]

were they hard to remove. i have gtrommets here ready to fill but dont know how easy it will be.

[bakkipouch]

were they hard to remove. i have gtrommets here ready to fill but dont know how easy it will be.

easy pesy mate a child could do it

[amery_vtr]

were they hard to remove. i have gtrommets here ready to fill but dont know how easy it will be.

Easy as pie mate, took me about 3 minutes...just remove the door card, snip away the pins, replace door card and stick a rubber grommit in the hole of the door card. Childs play matey:y:

[badasssaxo]

Yes Was Very Easy To Take Off Pins, Remove Door Card And I Used A Hacksaw To Remove Them.

[tif992ss]

You are better off fully removing the pins rather than cutting them , then ther's no chance them will jam the lock up at a later date
Aid

[badasssaxo]

good point didnt think of that, rubber grommets from halfords worked a treat 13mm worked best if anybodys interested.

[gozzy-vtr]

were they hard to remove. i have gtrommets here ready to fill but dont know how easy it will be.

theres a how to guide on doing this mate easy peasey! even i can do it :P