Wheel paint remover

[conor]

Any good things out there to remove the paint? Yea sanding and sand blasting but is there anything like a spray and leave it for 24hours sort of job. I heard baking soda?

[sharpie]

some people use nitro mors but i just sanded mine. media blasting/powder coating would undoubtably be the best finish - i'll be getting mine done at some point.

[AlexR]

It depends, if you are doing a same colour respray then sanding is good. I need to do a refurb and colour change from black to white so i need bare metal. I shall be nitromorsing, then clean them, then chemical metal the damaged areas, then a fuckload of prep and painting.

[lavo-vts]

nitromors is good worked a treat for me

[Jackman]

I used that nitro stuff when i was refurbing my old steelies!

[steviet]

ive just used nitromors for mines aswell.

[tommyVTR]

nitro mors, wallpaper scraper and plenty of harsh to fine grade wet and dry!

make cuts in the paint & be generous with nitro mors and the paint will peel off like a bannana skin. - providing u use a wallpaper scraper to chafe it off

[Mochachino]

nitro mors did it fine for me aswell, wack LOADS of it on, does a good job, if you dont want to go right down to bare metal dont use a scraper, use a scrubbing brush/nail brush or a brillo pad. Thats the mistake i made, used a wirebrush and scored the primer loads, proper bollox :n: :(:(