Have a guess?

[matt-88]

Ive had my vts for just over a month, Havent driven it that hard, only a few times up basvegas. But like normal i was driving home just having a nice cruise then as i turned left on to my road... !!BANG!!

I thaught it was a puncture so i stoped straight away as didnt want to ruin wheel but that was'ent the case.

My whole car when im sitting inside is now vibrating quite hard.


I cannot see ANY damage to the engine bay area. Has this happened to anyone else.??

Any guess's at wat this could be. I have my own guess but just want to see what you all think..... Cheers

[Sparco_Tom]

drive shaft? wishbone? suspension?

[matt-88]

drive shaft? wishbone? suspension?

All the stated are fine....

Any other ideas?

[Easty-5]

Engine mount went or gearbox mount??

Exhaust fell off hangers?

A rock chipped up under the car as you went over it?

You crashed??

You farted??

Am i close?? LOL

[darkslag72]

driveshaft, anti roll bar, suspension, tracking ????????? lol i have no idea

[Sean]

i guess you should have posted in the saxo problems section, seeing how it's a problem with a saxo?

[craig180]

Gearbox? Are you asking for advice or just wanting people to randomly guess what's wrong with your car?

[Sparco_Tom]

could it be internal? ie big end? crank etc?

[Sean]

pure spam tut tut

enjoy your last 2 minutes on sax-p ;)

[Lozza_vtr]

Engine mount.

[saxo19870]

sounds like what happened to my gti mate, engine mount under the ecu!

[vtrchrisvtr]

its the engine mount under the ecu mine went last month easy to repair your self

[pjsaunders06]

Its engine mount matey, take it to a garage. If one person sits in car and another pushes engine upwards the vibration will go away

[matt-88]

No you were all helping me... Lol

My suspision was mount but all of you have confirmed it now.

Thanks hope you all had fun guessing :clapping:

Oh and sorry yes it should have been in saxo problems sorry

[Mini-valver]

Definately the mount under the ECU mate. It'll look like this...

http://i172.photobucket.com/albums/w6/mini-valver/DSC00010.jpg

Drill the snapped bit out of the mount and replace with a new bolt. Peice of piss DIY jobbie...

[matt-88]

Nice picture mate, That looks nasty. Where can i get the bolts from.?? Just incase i do not get bots with my new mounts??

[Mini-valver]

You dont need new mounts mate! Just get the snapped bolt drilled out and get a similar length one from a hardware store!

[matt-88]

too late mate, Ordered two group n mounts from skip brown today. Will order the other 1 next week.

Thanks all for confirming mount

[Mini-valver]

Lol, at least it's sorted dude!