bonnet dont allign

[Aaron]

i got a new bonnet.

lined it all up.
and changed the clips over.
and the bonnet clip wont go under the frame.

I think the Front beam has been pushd down.
and the Bonnet catch from inside the car that one doesnt clip in.
it does for distance.
but dnt go down anymore for it to clip in.
the handle does go under the clip in

I Think I No What I Need to do.

Just wondering If Anyone could shead some more light on this and mayb help me?

thanks:y:

[Aaron]

Its Like The Bonnet doesnt allign right as the front beam across doesnt fit into the right place?

and b4 sum1 says is it the right bonnet

yea it is Lol :y:

[pepper953]

if you crashed the front panel will prob be out of alignment

[Richy25988]

yeah your slam bar has been pushed back, get another one from a scrappy cost me a fiver

[Leemc2008]

Fit some bonnet pins..

[Dan-Subtle]

Repair the slam panel, no point in doing a repair job if your not going to do it properly.

[stevo67]

Get the vehicle checked out by the pros,in other words on a jig then any adjustments can be made by them.

Steve

[yd51vtr]

new slam panel is only £35

[Aaron]

Is A New Slam Panel hard to fit?

[Agent_Orange]

No, not difficult just takes some time and basic tools. There's a thread on here somewhere by someone detailing how to do it.... giz a mo....

[Agent_Orange]

Jay-VTR was a busy boy a while back and produced the following thread, titled:

"Slam Panel Bumper Headlight Removal HOW TO GUIDE"

Just what the Dr ordered - Good work that man! :)

[Aaron]

Thank You:y:

[Quick]

You could try adjusting the big bonnet pin!

[Aaron]

Tryed it.
:(