Anyone know how to wire up a rev counter to actual dials?

[Harv]

Basically i've put some 1.1 dials into my 1.0 as it didn't have a rev counter. Later found out that it still doesn't work as it obviously doesn't have a wire going to it. Is there anyway I could wire this up?

Thanks
Harv

[WelshyUK]

I know that the rev counter works off the coilpack but I couldn't tell you which wire would be required.

[Tringaling]

did you have the anologue dials..with the clock...i swapped my ones with the clock for a revsmeter and it was a str8 swap :s

[Harv]

did you have the anologue dials..with the clock...i swapped my ones with the clock for a revsmeter and it was a str8 swap :s

Yea I know, heard about this. Yea I had a speedo and a giant clock. So swapped if for a mk1 1.1 clocks that show the revs as well. Doesn't work on mine. Must be a difference between 1.0 and 1.1 :homme:. Just looking to wire it up so it actually works :y:

[Tringaling]

stupid difference..cant keep anything the same can they? lol oh right..there is a wiring diagram sumwere on the web dude! its a big place lol

[Harv]

I'm guessing its something to do thats listed in here on the diagrams:
http://www.saxperience.com/forum/showthread.php?t=24339

I have no idea what they really mean though lol. Anyone like to shed any light :p?

[Harv]

Bump!!!

[VTS_Gaz]

Not sure about saxos but i fitted a rev counter into a mates Ka and took the feed off one of the ecu wires

[Harv]

I know you can tap into the grey diagnostics wire or even put a new wire into the ecu. But havn't got a clue to which the wire goes into which port and even which of the 5 dial connections. Hmm, doubt this is going to work :homme: