Where to moutn a harness??

[Spanky]

Hey guys, getting myself a 3 point sparco harness in errr about 3-4 hours,

Im going to be mounting it to the top rear seatbelt mounting, then at the seat, one side will attach to where the stnadard seatbelt is atached, but im puzzled as to where the other bit will fasten down.....

I have cobra monaco seats and subframes, will i have to get somthing welded, or will there be a hole or what....?

I cant look at the car atm as i dont have it

Also what kind of bolt would i need to secure everything etc etc

Any help would be great :)

[dave-saxo-vts]

alrite mate you need some bolts wiv the round hole on the end and they screw into the whole for the seatbelt slider down by the door

hope this helps :)

[Spanky]

see where the metal bar is between the door and the seat which would usually hold the loop of the seatbelt fabric i will need to put a eye type bolt in??? i was jst going to put the bar thru the metal fixing on the harness...

I was mainly wondering where do i attach the sidewhich goes down where you would usualy clip your standard seatbelt into, between the set and the handbrake........

[j8nno]

Theres no fixing point where the original seatbelt tensioner was. You either have to weld up a good fixing point on the subframe, or bolt through the floor where the tunnel is. I have same prob mate. Im gona go through the floor