View Full Version : Plastic Wheel Arch LInings
VTRacer
13th June 2008, 19:30
how easy are these to take off anyone thanks.
Bally
13th June 2008, 19:40
there not to bad mate i think there are just a number of clips holding them in, no bolts as far as i could see when i had mine out!
VTRacer
13th June 2008, 19:44
ok kool does it give much more room once they out mate.
tobomoto
14th June 2008, 17:36
yeah just clips in. the clips are crap though. ive had both sides fall out! still need to replace the drivers side. doesnt give a lot more room really (im guessing for clearence issues?) but you get a lot of road crap on the inside of the door. not good for the hinges.
badasssaxo
15th June 2008, 19:24
if you take them out the inside of your doors will get wet when driving in rain and may ruin speakers
stevo67
15th June 2008, 21:23
Best way to get them out is with a trim clip remover,that way you won`t break the clips.
Steve.
dalecheesy
15th June 2008, 21:45
there should be a torx screw at the front underneath where it attaches to the bumper.
Claire-VTR
16th June 2008, 10:22
super..i was wondering this too as some old frigger drove into me a while back & then took off!! Grrr!!!
His dumb towbar made a dent just above the front arch, looks like itll just pop out..might give it ago.
ox45
16th June 2008, 10:32
you have cables attached to the inside of the driver side arch aswell so it is best to keep the trim on
Coonper
16th June 2008, 10:37
Just put your car on full lock then floor it!:D
Nah, seriously, on the back its just clips i think, but on the front there is a lug attatching it to the bumper with a bolt through it.
vBulletin® v3.8.2, Copyright ©2000-2025, Jelsoft Enterprises Ltd.