PDA

View Full Version : My door creaks, groans and is becoming a nuisance!


benJee_VTR
1st July 2008, 13:54
how can i adjust the door? it's as though it clicks when i open it. any suggestions?

KayPee
1st July 2008, 13:57
how can i adjust the door? it's as though it clicks when i open it. any suggestions?

Do you mean when u open the door? If so Saxos have a tendency to lose the attachment for the door restraint arms inside the door, check it out, tighten and lubricate as necessary ASAP. I have seen these punch a hole in the outside doorskin!

Or do you mean the door drops when u open it? That can be worn door hinge pins, need replacement.

Or is it just when driving it? That could be door catch / striker plate needs adjusting / lubricating.

gonnacatchalunker
1st July 2008, 14:01
yeah check the "restraint" not the actual hinges, this often becomes loose and makes nasty noises. make sure that evrythin looks in place then tighten it up, maybe 40 torx head on the car side and bout 10mm nut on the door side.

benJee_VTR
1st July 2008, 14:08
what bit is the restraint? the little bit tht sticks out to stop it swinging too far?

KayPee
1st July 2008, 14:19
what bit is the restraint? the little bit tht sticks out to stop it swinging too far?

Yup.... the flat bar between the door and the car frame. it becomes loose at the door end (inside)

benJee_VTR
1st July 2008, 15:38
and how can i adjust it?

dustcapart
1st July 2008, 15:42
there are two torx key holes size 6(dont quote me on that) tighten those they should stop the noise

nick

alexius06
1st July 2008, 16:11
these are common problems, the door check strap pins wear out due to obvious constant use, all u can do really is tighten the 10mm nuts where it goes into the door, and the torx 40 bolts that go into the car chassis, there is also a pin that you can replace which is on the hinge by the torx 40 bolts. otherwise just buy a new door check strapm relatively cheap and easy to fit.

benJee_VTR
1st July 2008, 16:47
these are common problems, the door check strap pins wear out due to obvious constant use, all u can do really is tighten the 10mm nuts where it goes into the door, and the torx 40 bolts that go into the car chassis, there is also a pin that you can replace which is on the hinge by the torx 40 bolts. otherwise just buy a new door check strapm relatively cheap and easy to fit.

ok cheers for your help lads, will get on it! repped