removing rear badges

[adamm]

i know how to get them of and so on but could i not just cover the holes left with something easy a do the spraying over that any one know any guides

[DevilDamo]

If you only spray a small area, it'll be noticable unless it's blended in very well with the existing paintwork. Depends how much of a decent job you want.

[adamm]

i would wan tit to look like they were never there lol guess that idweas out the window for now

[L33h]

bodge over... loadddds of sanding and a full respray off the boot. not cheap

[Chris_O]

just sand the badges down and tcut them for the time being, i did mine the other day and just waitin to figure out what im gona do with the holes!lol

[adamm]

ide rarther decide what to do with the holes after say if i take them off a wanted to colour them what bits do i need woulkd just a spray and laquer do?

[stevo67]

Plus plastic primer m8.


Steve.

[MrHouston]

Just spray them the same colour as your car, saves paying to have 5 little holes filled up and your whole tail gate sprayed

[flee123]

It will more than likely need the full boot respraying as its near impossible to blend out from such a small area.

Wouldnt bother with T-cutting. Might as well scotch, prime and paint them. Get a much better finish.

[Russon]

Personally i wouldn't remove the badges off any car... unless it was a Rover badge. Weighing up the pro's and con's it's not worth the hastle.