lowering. What would look best?

[Aaron]

pic of my car

front will be on 55mm springs

want looks
not handling

what would people reccomend FOR LOOKS

thanks
http://i35.tinypic.com/2n9djbp.jpg

[frankie]

65mm rear.......

nice and level........

[Aaron]

i tryed to get a photoshop
but they couldnt tell me what mm it was
so it wasnt much help tbh


i was thinkin about 70mm rear


ralli art mudflaps will be goin on
so i just want them like a few mm off the floor but can always cut down:)

[Aaron]

spline wise
how low is 2 splines?
and how low is one spline?
and 3?

[TU-Tuning]

Most people on here say its not the proper way to lower a torsion bar mate. I think that its not a bad way of doing it, but youve gotta be really careful you dont unlodge the bearings from their housings.

1 spline is about 30-40mm
2 is 60-80mm
3 is 90 -120mm

It depends on which arm you pull off compared to the end of the torsion bar that gives you that variance

[Aaron]

ive decide
55 on front
70 on back

could someone do a photoshop to this size?

[Aaron]

i wanted to no what the spline mm was out of intrest
i no its not the proper way
get your tape measure out
:)

thanks

[Goldsax]

Well as you luv me, ull go with my 55mm n 65mm rear :D haha lol