Laying Cables

[D_Man]

hi all,

i own a mark 2 furio. i need to take the carpets up to lay some cabling to the boot. i was wondering how much of a pig of a job it will be??? i plan on laying the cables durin my week off (next week) then doin the install next month. also if n e 1 has a guide to show me how to do it, it would be very helpful ta!!!!

cheers guys!!

[Scott]

piece of piss, pull up the rubber seal, use a flat blade screwdriver to prise up the metal clips holding the carpet down.

[S9_DAN]

It is well easy, as scott said pull the rubber seal and prise the metal clips, i took the passanger seat out aswell just makes it easier and you can put the wires down a bit more.

[Propagand]

There's 4 torx screws holding the seats, unscrew them and remove passengers seat.

Remove the passengers side bolt that holds dash.
You need 13mm wrench for that.

Remove the other end of the seatbelt, you need 19mm wrench for that.

Remove the backseats and remove the holdings, you need 10mm wrench for that.

Remove the doors sealing and remove the metal clips.

That's all about it.. Happy cabling smileys/smiley2.gif

[Yates]

u dont really need to take the seats out tho i dont think, as scott sed take up rubber seal, i used a pair of thin nose plyers to take up the clips, not where it bends over the metal but where it goes into the carpet grab that bit n pull up.

ive got the power amp lead down the passenger side and then the wires goin from the head unit down to the amp down the drivers side.

also the gromit for the power cable to go thru to the engine bay is behind the glove box, i took the glove box out, theres a little metal bit underneath the glove box, that slides over once unscrewed then u can get the glove box out smileys/smiley14.gif

good luck!

[D_Man]

cheers guys, i will be tackling this in the middle of the week.

thanx again!!!! smileys/smiley14.gif

[D_Man]

ok, my ice setup is in and running great!!!!! if i knew how to post pics i would. cheers for your helps ppl!!

dennis

[Yates]

no probs!

up load them onto

www.photobucket.com

then it wil have a link under each photo, copy that, then where u post ur reply click on the little tree button and then paste the link from ur photo into there and it should work!

[D_Man]

Ok im goin to attempt to put these pictures up, here goes:

http://i17.photobucket.com/albums/b84/Dennis_W/P1010012.jpg
http://i17.photobucket.com/albums/b84/Dennis_W/P1010008.jpg
http://i17.photobucket.com/albums/b84/Dennis_W/P1010010.jpg
http://i17.photobucket.com/albums/b84/Dennis_W/P1010009.jpg
http://i17.photobucket.com/albums/b84/Dennis_W/P1010013.jpg
http://i17.photobucket.com/albums/b84/Dennis_W/P1010011.jpg

Dennis

[D_Man]

http://i17.photobucket.com/albums/b84/Dennis_W/P1010008.jpg