View Full Version : Important! : Fusion sub , amp and component problem
garvey2k8
11th September 2008, 11:30
i just bought a fusion sub and amp of a mate new i got a wiring kit with it to i need help as i dont know were the wires go
Red : Battery
Black : earth
There is a blue cable a phono cable and the sub cable were dose the blue wire go on the headunit and were do i plug my comp[onents speakers into
Help and advise would be helpful
Cheers
pjm300
11th September 2008, 11:33
better off asking this in the ice section mate.
do you have an aftermarket head unit with the RCA connections?
sax_vtr196
11th September 2008, 11:45
i just bought a fusion sub and amp of a mate new i got a wiring kit with it to i need help as i dont know were the wires go
Red : Battery
Black : earth
There is a blue cable a phono cable and the sub cable were dose the blue wire go on the headunit and were do i plug my comp[onents speakers into
Help and advise would be helpful
Cheers
Blue cable - remote cable, there should be a blue cable at the back of your head unit to connect this to. Your amp will not work without it. once connected at the head unit, there should be a remote slot on your amp!
Phono cable - Most head untis have phono outputs on the rear, if so plug them into something like (rear output) or (sub output) and they should plug straight into your amp!
Depending on what amp u have, but mostly all your component speakers will wire straight into the back of the head unit, look for 2 x the same colours, should be 4 colours.
If possible it is advised that you run your power cable down one side of the car and all others down the opposite side to reduce interferance.
Remember to bolt you earth cable to a nice clean shinny piece of metal in your boot.
Hope that helps you! :y:
garvey2k8
11th September 2008, 11:49
cheers for the help i will tryb tonight and post the outcome cheers m8
vBulletin® v3.8.2, Copyright ©2000-2025, Jelsoft Enterprises Ltd.