Threaded Screws

[tiptop]

Hi im trying to remove my coil pack from my vts but the previous owner has rounded off every single torx screw how would i go about getting these out?
cheers

[Peejous]

Have you tried getting a flat blade and a hammer?

Place flat blade into top of torx screw hit with hammer.

Try and unscrew them

Other than that you may have to drill them and re thread it.

[Peejous]

Two posts ftl

[Rob]

I use a dremel with a fline cutting disc, cutting a single groove into the head of the bolt, then using a flat headed screw driver unscrew the bolt as if it were a simple screw, crude but quite effective.

[tiptop]

cheers i might try that and is it ok to be wacking the top of my engine with a hammer?

[Peejous]

When I say hit it with a hammer I dont mean I sledge hammer.

Just enough to get a groove or dent in the screw that you can use to turn it.

[tiptop]

ok thanks for the help im going to have a bash at it now

[fkvtr]

I use a dremel with a fline cutting disc, cutting a single groove into the head of the bolt, then using a flat headed screw driver unscrew the bolt as if it were a simple screw, crude but quite effective.

^^ Like Rob said. If u dont have a dremel you could used a hacksaw to cut the groove or if there is room around the screw you cud try locking vice grips onto it to turn it.