amping components

[NIsaxoVTR07]

where is the best place to put an amp, when amping up components?

[Ashleyp]

where is the best place to put an amp, when amping up components?

wherever you want

[Coonper]

In the boot is the obvious place, but they can be put under the front seats, under the dash, in the glovebox.

Depends on the size of the amp tbh mate.

[NIsaxoVTR07]

would you just run the cables under the carpet then i take it? if you dont amp up the components, is it possible to run both the speakers and the tweeters through the crossfader?

[Stickyjam]

under carpet ja
and amp them to get the most out of them, dont take the easy way out you wont be anywhere near as happy...

[NIsaxoVTR07]

no problem i think i might just do that!! ive got a set of 6x9's lying about so i might just sell them to raise funds for a bigger amp. would i need a 2 channel amp to run 2 subs and the components? ive got a 1000w kenwood amp at the moment no too sure how many channels its got though.

[Ashleyp]

no problem i think i might just do that!! ive got a set of 6x9's lying about so i might just sell them to raise funds for a bigger amp. would i need a 2 channel amp to run 2 subs and the components? ive got a 1000w kenwood amp at the moment no too sure how many channels its got though.

2 or 4 channel amp for the comps (4 channel will be bridged) & mono block or high powerd 2 channel amp for the sub

or high powerd 4 chanel amp - 2 channels for each comp, and the other 2 channels bridged for the sub

1st option is miles better

[Predator_R32]

you could also make a false floor for one of the passenger footwells, tbh id rather have them i nthe boot under a false floor with plenty of air circulation

[NIsaxoVTR07]

i think at the moment i am using both the channels for the two subs, can i use one channel for both the subs and one channel for the components? or would i be better getting a 4 channel amp? cheers