Drilled through both brake lines by the sill

[Sparco_Tom]

I drilled through both brake lines by the sill today. I cant find the replacement pipes anywhere been searching since 6pm.


Please somebody point me in the right direction

[TU-Tuning]

Just get connectors made up and cut the section out mate. You can get copper pipe with any fitment connector on it for feck all down a decent motorfactors. Get the same connectors fitted to the ends of the fixed pipes and fit small sections in to replace the damaged area. Think its about a pound per foot normally so will cost under a fiver

[saxo_kid18]

go to halfords mate there open all day and make your own

[DanT]

go to halfords mate there open all day and make your own

What lol.

Sorry im no help tom. Unlucky on that though mate.

[frankie]

go fully braided ;)

PM swampy

[r_i_c_h_1]

It's all very well saying 'replace small sections' but unless you have a flaring tool, which isn't the easiest thing to use with the pipes on the car anyway, this isn't possible.

Do you not think citroen would sell parts for it?

[Sparco_Tom]

i was looking at getting a flaring tool last night. i will be visiting citroen tomorrow see what they quote me for the parts.

i cant believe i done it i won the tosser of the year award and its only february

[swampy]

citroen will do them but thye aint cheap

best way would be to measure them from the nearest two unions and get a facotrs to make up new lengths

it will be alot cheaper and quicker than citreon

or i could supply them to you given the dimesnions
would take a couple of days to sort

[Sparco_Tom]

i will get a price tomorrow and then i might get back to you once ive taken another look at them