where can i buy some better arches

[jack123]

i have a saxo 1.1 and wanna get some clip on arches anyone no where i could buy some to clip on??

[PETE-VTR]

i had some on my old 1.1, looked quite shit imo bu my mates liked them ill find you a link...

front ones looked like VT but rears were a tad different.

1min

[jack123]

i dont mind i just wanna get to make it look a bit better
:P
and thanks

[PETE-VTR]

ahh carfnt find the link mate, ill keep looking tho:y:

[jack123]

ok mate where did u get it from and what could i type in to find them?>

[PETE-VTR]

couldnt find the arches you mean matey

but iv linked these VT kits for you. there cheap enough.

http://cgi.ebay.co.uk/citroen-saxo-vtr-p-reg-full-body-kit_W0QQitemZ130295794807QQcmdZViewItemQQptZUK_Car sParts_Vehicles_CarParts_SM?hash=item130295794807&_trksid=p3286.c0.m14&_trkparms=72%3A1689%7C66%3A2%7C65%3A12%7C39%3A1%7C 240%3A1318

http://cgi.ebay.co.uk/saxo-bodykit-bumpers-arches_W0QQitemZ180338032411QQcmdZViewItemQQptZUK_ CarsParts_Vehicles_CarParts_SM?hash=item1803380324 11&_trksid=p3286.c0.m14&_trkparms=72%3A1689%7C66%3A2%7C65%3A12%7C39%3A1%7C 240%3A1318

[jack123]

thanks i just really want the arches and mayb the back bumper

[jack123]

i found some on ebay but dont no if they will fit my car cus they are vtr ones

[LeeM]

all you cn get if its just arches your after. look poo imo and no idea where to buy them
http://www.saxperience.com/styling/arches.php?page=2

[jack123]

would vtr ones fit my desire?? i only lookin for back lot of arches?

[Saxo-Mike]

couldnt find the arches you mean matey

but iv linked these VT kits for you. there cheap enough.

http://cgi.ebay.co.uk/saxo-bodykit-bumpers-arches_W0QQitemZ180338032411QQcmdZViewItemQQptZUK_ CarsParts_Vehicles_CarParts_SM?hash=item1803380324 11&_trksid=p3286.c0.m14&_trkparms=72%3A1689%7C66%3A2%7C65%3A12%7C39%3A1%7C 240%3A1318

If only this was closer to me :wall: I would have the full kit allready sprayed in my colour :n:

[jack123]

would it?

[Saxo-Mike]

If you wanted to put vt* arches on you would have to cut away some of the flat arch take a look at this guide a member did

http://www.saxperience.com/forum/showthread.php?t=55973

[jack123]

do i have to cut anything or can i just like tiger seal it on cus i just wanna make it loook better

[Saxo-Mike]

yea you have to cut away the rear arch about a inch and half as it hangs lower than a vt arch

[jack123]

hmm dont no if ill get one den cus i dont fancy cuttin my arch lol

[Saxo-Mike]

ive not done it yet but it doesnt look too hard tbh

[Kenco]

im doing mine soon mate
tbh its not that much hassle i dont think, just a careful hand and it should be fine

[Sparco_Tom]

you mean i will end up doing it lol

[Kenco]

lol fuck off!
(do you have an angle grinder? :hug:)

[Sparco_Tom]

yep i do 40quid to rent it lol

[Kenco]

haha
i will give you saves on a cigarette and thats my final offer :homme:

[Sparco_Tom]

deaaaallll

[Matty_VTR]

why not have a look at 106 GTI arches.. I think they would look good on a flat arch saxo.

[jack123]

would 106 gti arches fit on my saxo??

[jack123]

anyone no where to get arches?

[MartynJ]

worth a look on ebay mate :)

[jack123]

would it look odd with just back vtr arches on??