carpet sticks out!

[jware92]

ive routed all the cables along where the carpet meets the blakc rubber around the door.
now the carpet wont sit back under the rubber.
what have you people done to yours?

[Ashleyp]

lift the rubber up, the carpet clips are there, push the carpet under and push the clips on tightly

then push rubber seal back on. job done

[AlexGreen]

Why would you put the cables there?

Pull the rubber off all around the bottom of the door and then prise off the metal carpet clips.

On the passenger side the cables are run underneath the carpet so just pull the carpet back in the footwell and run your cables with the existing ones. When you get to the seat. lift the rear carpet too and you should be able to fish them through.

Do the same on the other side although there are no cables run under the carpet just run them as close to the drivers side as possible so there is no bulge under the carpet.

Pull the carpet back into posistion and clip it down again with the clips. If you cant push them onto the metal get a screw driver and a hammer. Replace the door seal and you're done.