View Full Version : Flywheel.... any ideas ?
Godz Racer
9th January 2003, 02:48
Hi to all...
I have a saxo 1.6 vts and I cannot find ANYWHERE (especially here in Greece) a flywheel to put.
Any ideas ?? By the way, citroen's flywheel weights 5.7 kilos... (very small and light don't u think). How many kilos do you think would be appropriate to lighten it, without having any problems ?
Thanxxx
</font>
axsaxoman
15th January 2003, 02:16
depending on power output of engine ,you could remove approx 1kg,take it from round the edges most as it has more effect there .but to be honest i doubt you will notice much difference,only that it will idle worse,thats what the flywheel is for ,that and somewhere to mount a clutch to. i can sell you an aluminium version with special steel insert approx£300 ,but no point for road car
Bucky
20th January 2003, 14:56
I lightened mine and took off 0.9KG, it did make a difference but it's something i wouldn't pay for unless it was cheap as the gain isn't that big.
I revs better up the high end though.
Godz Racer
22nd January 2003, 05:14
Hey guys thanx.
I eventually took off 1,3kgr and.. believe me..
I've noticed difference, especially at the higher rpm.
Axsaxoman, I keep in mind the aluminium one,
perhaps in a few months I'll need it. Can u tell me, how much does it weight ?
</font>
axsaxoman
24th January 2003, 00:22
weight is approx 2.7kgs,when you need one i will check weight for sure.clutch will be heavier ,so think of chnaging to paddle clutch at same time
vBulletin® v3.8.2, Copyright ©2000-2025, Jelsoft Enterprises Ltd.