my grill

[jack123]

i messed up my grill i think its not flush in one corner and was thinkin should i glue the corner what do you guys and ladies think???

http://i678.photobucket.com/albums/vv148/jack_042/Image037.jpg


http://i678.photobucket.com/albums/vv148/jack_042/Image036.jpg

[BrightSpark101]

Are you sure its not just a missing torx screw? if not im not really to sure. If you glue it over time it will weaken and come off again. what about good old cable ties?

[J222JRA]

is it the mesh thats stopping it from sitting flush mate?

I wouldnt advice bonding it in.

[newqs36]

i had this problem when i did my grill i was forever trimming and refitting. in the end it was that i did not get the part with the screw holes bonded back on properly(i followed a guide on ere somewhere) i ended up going back to the original

[jack123]

well i cut off the screw mark on one end and its just cliped in and im just thinkin bout glueing it in one end cus in the middle and on the other side is screwed in so i think it would be on illl look see if there is anywhere to cable tie it but i dont think there is

do you guys think it looks ok like that or do u think i should just get a new one?

[jack123]

is my grill mk1 or mk2??

[J222JRA]

mk2 mate

[jack123]

ok thanks dude how should i fit that one corner???

[J222JRA]

i would just mess about fitting it mate, mine was an arse but i got there in the end.

[jack123]

ill keep tryin i wannt paint it black

[kirtisb]

i used 5 cable ties for mine as glue was crap. i also had to cut about 2mm off the parts that stick out for where the screw goes it. looks good now and hasnt fell off