PDA

View Full Version : Map sensor


badger26
4th May 2009, 17:39
Can anyone tell me where the map sensor is??

Andy_K
4th May 2009, 18:52
On the bulkhead at the rear of the engine bay. Left hand side as you look at it. Its the black box with a thin hose running to it. At least thats where is is on a MK1 VTS

Liam_
4th May 2009, 19:41
It's on the front, left hand side of the inlet manifold. Has what looks like an 8mm bolt holding it on and a plug leading to it.

badger26
21st May 2009, 19:19
cheers mate is that the part which is on the alternator??

BobC
21st May 2009, 19:51
Nope. Not even close.

It looks like these: http://shop.ebay.co.uk/?_from=R40&_trksid=p3907.m38.l1313&_nkw=saxo+map+sensor&_sacat=See-All-Categories

It will be bolted to a round black cylinder attached to the top of the inlet manifold. Top left-hand side of the engine bay on a 52 VTR.

badger26
21st May 2009, 19:56
Ha ha as you can tell i aint gotta clue mate thanks! My problem is the car feels jumpy when idle and can rev upto 2000 revs without touching the pedal could the map sensor be the problem??

BobC
21st May 2009, 20:00
Ahhhhh, perhaps you should have asked that first!

There's alot of other stuff that could cause this before the map sensor would be a likely candidate.

Check these:

1) Idle control valve: http://www.saxperience.com/forum/showthread.php?t=174710
2) Coolant temp sensor: http://www.saxperience.com/forum/showthread.php?t=195050

badger26
21st May 2009, 20:10
Thanks mate all looks very complicated but il have a bash!!

Liam_
21st May 2009, 20:10
MAP sensor, ICV or coolant temp sensor.

MAP sensor would be my first port of call. I've circled it here for you (http://i626.photobucket.com/albums/tt348/leeumh/map.jpg). Unclip the connector, remove the 8mm bolt and pull it out. Give it a spray/ wipe over with WD40.