2 questions. help please

[wood-ives-saxo_1_1]

firstly is there any where that sells replacment switches for the windows in the centre console thingy.

and secondly this might be a dumb question but how do i no if my r reg 1.1 sx is a mrk 1 / mrk 2 ..phase 1/ phase 2 etc

thanks

[J222JRA]

its a mk1

ebay or breakers yard for the switches

[wood-ives-saxo_1_1]

is phase just the same as mark?

and i was meaning like a different type of switch you no colour etc. or would interier spray work on them?

[J222JRA]

phase and mark are the same mate

u would have to spray the badges if you want them a different colour

[wood-ives-saxo_1_1]

so a phase 2 grille wouldnt fit my car then??

[LT_TA]

nah phase 2 grill is in the bottom wer as the mk1 grill is basicly the whole front between the headlamps

[wood-ives-saxo_1_1]

will a vtr bumper fit my car???

[BenjaM]

http://www.youtube.com/watch?v=cPycbYWRqEM

[liam-o]

phase and mark are the same mate

u would have to spray the badges if you want them a different colour

phase breaks up minor changes in the mark, for example the 90bhp mk2 and the 98bhp mk2 VTR

ph1 and ph2

no difference though apart from the engine

[Ben_L]

mk2 was from 2000 onwards, as said there is not much difference. Only the fornt end and the seat paterns. VTR bumper will fit with some minor modifications. it does look good though and if you have the time and patience i'd say its worth doing :)

[wood-ives-saxo_1_1]

will it look ok without putting side skirts an rear bumper on but lowering the car?

[liam-o]

will it look ok without putting side skirts an rear bumper on but lowering the car?

from the front it will look amazing, VT front bumpers look good (make sure you fogs for the extra 10bhp lol)

personally i dont like flat arches, they look too skinny

like said above, you will need to modify the sides of the VT bumper to pull it in so it sits flush with the front arches