strengh carbon

[rorz_vts]

i purchased a new coil pack cover from streamline carbon but it doesnt have the holes for the screws to go through, am i able to just pin it an get a fine drill piece an do it my self or is there a special way to have it done as i dont want to reck it
cheers rorz

[Tabzman]

Im pretty sure its going to be ok with a fine drill bit tbh, Get some masking tape over the bit your drilling and mark it up, this should prevent any cracking or splitting while drilling, reason i say this is cus a friend drilled some holes into the carbon fibre console he bought and it was ok

[Sparco_Tom]

very very thin drill bits working up at.5 or a mill at a time. it can soo easily shatter

[Ryan]

thats pretty poor for the price that you have to drill it yourself.

[Tabzman]

very very thin drill bits working up at.5 or a mill at a time. it can soo easily shatter

Can it really? I didnt realise it was that fragile, good job my friend did his carefully. Thought carbon fibre was meant to be reasonbly strong these days.

[Sparco_Tom]

carbon is very strong and very light. but when it does decide to break its shatters and flys everywhere normally into your skin and eyes lol

[Tabzman]

carbon is very strong and very light. but when it does decide to break its shatters and flys everywhere normally into your skin and eyes lol

Goggles it is then lol

[miamibluebaby]

lol ye shoud be fine if you take your time like with most things be patient