Lowering Torsion Bar

[That-Guy]

Just wondering really. I have a PUG XSI and the back is higher than the front. It has not been lowered at all.

Do you think its worth dropping the Torsion Bar slightly to match the front or will I need lowering springs for the front?

Just looking for a bit of advice really :)

[-Dan-]

The back should always be slightly higher than the front, even out of the factory, but if it's a really noticable amount then you should think about getting it dropped to match.

Lowering springs on the front will lower it even more, which means you'll definately have to lower the back, unless you want to look like a tractor.

It needs to be done by someone that knows what they're doing and will lower the proper way, rather than the 'notches' way though.

[That-Guy]

Ah right cool thanks for clearing that up. If there is meant to be a slight difference I will leave it be :)

Thanks Again

[DanT]

Ah right cool thanks for clearing that up. If there is meant to be a slight difference I will leave it be :)

Thanks Again

Or you could drop it a chilled 40-50mm? :P