axel stands

[Pricey_O]

Would it be ok do you think to have the front of my car then the back on axel stands for a couple of days while i refurb the wheels?

there wont be any issues with the weight of the car on the stands for the amount of time it will be on them

cheers for any help
:y:

[VTRelite]

will be fine as long as tehy are in the right place obviously

[Pricey_O]

yeh wheres the best place for the stands to go?

[VTRelite]

on the sideskirts the will be arrows - put them on the sill inline with the arrows

[Pricey_O]

on the sideskirts the will be arrows - put them on the sill inline with the arrows

is it big enough to put the stands under while the jack is under it aswel? as il have to jack the car up then put the stands on obviously, will the jack not get in the way?

[LeeM]

mine sat on stands for a week or so while i did my engine conversion, i used the front wishbone mounts. the only problem was the stands sunk into the soft tarmac on my drive

[Pricey_O]

mine sat on stands for a week or so while i did my engine conversion, i used the front wishbone mounts. the only problem was the stands sunk into the soft tarmac on my drive

ah right well if you had yours on for a week then im sure il be fine and il probably use the front wishbone mounts aswell

[Andy_K]

Will be fine as long as the stands have sufficient weight capacity for the car. Mines been stood on 4 stands for about 2 years lol

[gavin_t]

yer time isnt a factor as long as its done in the right places. And is on nice flat ground out of the way so there isnt people milling around all the time :y: