ford alloys?

[bullit91]

heya been looking at some ford alloys on ebay and they are the same pcd and will fit under arches.

however the offset is different by about 20mm what do i need to fix this and where can i get these bits from any help or knowledge on this would be great cheers.

[Tontsy]

spacers ... i know nothing about them, but have a look for them :D
always being talked about on here.

[15gazza]

have a set off ford rs2000 si alloys sitting in my garage that I would of put on but refurb'd the vtr wheels...anyway, you will need around 20mm wheels spacers to correct the offset. Best to use hubcentric spacers, but they aint cheap.
You also need upgraded wheel bolts obviously to accomodate the wheel spacers...I have a set of brand new extended wheel bolts suitable for 20mm wheel spacers somewhere...

[Sparco_Tom]

you need 20mm hubcentric spacers, sean_vts was selling some for a very good price. give him a pm

[cj_99]

you need 20mm hubcentric spacers, sean_vts was selling some for a very good price. give him a pm

they have sold now.


ford wheels usally have a different size centre bore aswell so you wont just need spacers you will need adaptors (which will be spacers aswell).

Saxo centre bore is 65.1
ford usally 63.3 or 63.4 or 63.5 depends where you look tbh

[SaxoAL]

they have sold now.


ford wheels usally have a different size centre bore aswell so you wont just need spacers you will need adaptors (which will be spacers aswell).

Saxo centre bore is 65.1
ford usally 63.3 or 63.4 or 63.5 depends where you look tbh

Or use centre rings/spiggot rings to adapt CB size

[cj_99]

Or use centre rings/spiggot rings to adapt CB size

Yeah or that :)