Bucket seat nightmares .... Finally Sorted

[jonathon5]

I have been struggling to get the seat height right in my tack car for ages, the problem is when you put your helmet on your head hits the roof :n:

So i swapped from a bottom mount seat to a side mount seat , I also used a sparco seat frame, after messing around for days i managed to get it to fit sort of.

So finally today I popped up to see Andy at Geronimo cages to see if he could get it to fit better. And he did :y: by using Cobra side mounts & bolting the seat direct to the floor without the sparco frame its a much better fit.

No banging your helmet any more & a much lighter solution :y::y::y::y:


I will put up some photos as soon as.

[Kev_Vtec]

i need my seats lowering. keep hitting my head lol

[M1VT]

wait a sec,you bolted your seat to the floor pan?
Mmm...safety

[scholesyy]

lol how tall are u guys?

[jonathon5]

i need my seats lowering. keep hitting my head lol

std seats ?

[jonathon5]

wait a sec,you bolted your seat to the floor pan?
Mmm...safety

No probs at all, mounting plates added underneath, big bolts & fabricated spacers for rear of mount.

[jonathon5]

lol how tall are u guys?

5ft 10" not that tall

[Kev_Vtec]

im 6,4! yes std seats.thinking of some new ones soon tho just so it will be lower

[Garry_T]

im 5 10 and almost rub with vts due to short stumpy legs and long torso

[scholesyy]

hmm i shud be ok then at 5ft 8. puttin some buckets in , in a few wks

[jonathon5]

hmm i shud be ok then at 5ft 8. puttin some buckets in , in a few wks

All depends on the mounts if you have a frame plus a slider it may be close.