Track Suspension set-up???????

[VTSTomE]

Right I need some guidance on what i need etc etc. Im going to be purchasing the bilstein group n's (not the tarmac spec 1's, the blue capped ones.) From what I have read and understand 21mm bars match these dampers, but what lb springs (was thinking around 225) would match and what arb's?!
Tom

[AlexB]

225 lb springs would be allright yea
as for arbs that's down to personal preference but most would go for a 24mm rear and a 22 front

[sexy_gt]

i use same bars as mentioned above. standard torsion bars and a 160lb set of springs. if driven on road you dont want a harder setup.

just remember the harder the suspension the less forgiving it is grip wise! hard setups dont go too well with wet and bumpy tracks :)

cheers
stew

[16vax]

i use pug sport front dampers and over 200lb springs salex dampers on back std vts bars and roll bar at the front done a wet track day at knockhill on acb10s with no probs

colin

[sexy_gt]

^^ just proves that everybody is diffirent. thats why we dont all run the same setup :)