Cov_Rob
16th September 2009, 13:32
I'm trying to tighten my arb using the method described in the stcky thread but i have a couple of problems.
I have snapped the bolt that hold the end plate on (the pear shaped plate) how do i get the plate off so i can drill it out?
Also, the M8 bolt i bought seems too big to srew into the ARB, it will go a little but just pulls out. I assume it should be too small to screw into the first smaller set of threads.
I need to get this sorted for 5pm if possible as i need the car for work.
I have snapped the bolt that hold the end plate on (the pear shaped plate) how do i get the plate off so i can drill it out?
Also, the M8 bolt i bought seems too big to srew into the ARB, it will go a little but just pulls out. I assume it should be too small to screw into the first smaller set of threads.
I need to get this sorted for 5pm if possible as i need the car for work.