Log in

View Full Version : Citreon/saxo Badges

kennysevenfold
20th October 2009, 08:20
Hey :D

How hard is it to remove these from the back of my saxo?
Any times to get them off easier?

Cheers.
iDaNz_VTR
20th October 2009, 08:29
easy mate , use a hairdryer and a old card to pull of :)
garvey2k8
20th October 2009, 08:54
i just prised mine off no hairdryer required but have you got the bungs for the holes behind or water will get in :)
kennysevenfold
20th October 2009, 09:01
Cheers guys.

Whats the bungs? lol

i thought they would just be stuck on?
JamesR
20th October 2009, 09:03
Why you removing them? To spray them or to de-badge?

If to de-badge there will be holes.

If to spray them, just prize them off CAREFULLY with a screwdriver.
iFurio
27th July 2011, 01:57
Bit of a shame it leaves a whole or two :( was wanting to remove miine
YourDreamGirl
27th July 2011, 12:33
Why you removing them? To spray them or to de-badge?

If to de-badge there will be holes.

If to spray them, just prize them off CAREFULLY with a screwdriver.

+1

I used a hairdryer to melt the glue, then slowly edged round them with a flathead screwdriver and prodded the pins from the back once they were loose.
danny-vts
27th July 2011, 15:26
nice 2 year bump, in future please have a look at the date on the left hand side!!
prior_vtr
27th July 2011, 17:08
just t cut them lol
CarteerMilees
27th July 2011, 19:45
Dont use a screw driver your make small dents around the badge, just worm them up with your misses hair dryer and get something thin so wedge behind them and slide off,
dj89
16th August 2012, 21:43
sorry to bump but when i got mine the badge had been removed leaving the pins in place i have removed th pins but there is like little wholes left i'l get pictures tomorrow.
bunty99
16th August 2012, 23:26
its annoying they leave holes.. i was wanting to debadge mine but as with alot of people i imagine soo as i realised it would have to be either welded or filled then sprayed!! stuff that live with the badges lol
danny-vts
17th August 2012, 00:55
sorry to bump but when i got mine the badge had been removed leaving the pins in place i have removed th pins but there is like little wholes left i'l get pictures tomorrow.

professional way....weld the holes, filler and spray.

pikey way.... stick 1p pieces behind the holes, filler over the wholes and spray.
StealthSteve
20th August 2012, 00:34
What's a whole?