what to do with wheel arch? pic up

[josh1989]

ok so located the noise i've been asking about and it appears to be that my o/s arch cover is loose and rubbing on the wheel bearing cover, i've no spare grommets to pop it back in and it looks bent out compared to the n/s one, any repercussions from removing it altogether or is there a better way to solve? i'll go take a picture and upload it in a minute :)

http://i819.photobucket.com/albums/zz118/josh_thegame_2009/DSC00252.jpg

[LSOfreak]

if you remove it , under the bonnet and inside of the doors get all muddy.

my front liner was rubbing at one point on the tyre due to being loose. threw a hacksaw on it and only rubs on full lock now :)
not even 'slammed', only down 40mm on a 45 tyre so no idea why it rubbs

[josh1989]

i'll try hacksaw some of it away then cheers :)

[farmerchris]

can you not secure it back with some wire ,or rivet it maybe.

[frankie]

the hole dear the side, ive used cable ties through thats and went round the brake pipe securing bit.

[josh1989]

the hole dear the side, ive used cable ties through thats and went round the brake pipe securing bit.

yeh tried this the bottom bit still sticks out cos it's bent

[josh1989]

sorted it with a mixture of tips, cut some away and tied it up to the hose behind the hole :D