View Full Version : axle refurb/swap in the south HELP PLEASEE
shanelalor
4th March 2010, 13:17
right im after aan axle specialist in the london area, i have heard about IMaxle and was really convinced untill i found out they were in leicester and thats too far to travel on a bent axle ! any help will be much appreciated i need this sorted asap
thanks
shane
MrHouston
4th March 2010, 13:17
Did you read they can post?
marcusd
4th March 2010, 13:20
krisb is in horsham, only hour drive or so he is on here and has his own section, and is top guy
shanelalor
4th March 2010, 13:43
yes i did read that they can post but id rather just take it somewhere they can fit aswell as giving them my axle in return
raunchz
4th March 2010, 13:44
yes i did read that they can post but id rather just take it somewhere they can fit aswell as giving them my axle in return
I'm sure they'll love taking a bent axle in px - not really tbh :P
Mochachino
4th March 2010, 13:45
Ye IMaxle collect your old beam and deliver your new one in the same postage cost.
But as said you cant fit it lol
Pieface
4th March 2010, 14:49
Ye IMaxle collect your old beam and deliver your new one in the same postage cost.
But as said you cant fit it lol
I doubt they'd take a bent beam in return. They take old beams to refurb, but wouldn't be able to with a bent beam would they?
Mochachino
4th March 2010, 14:50
I doubt they'd take a bent beam in return. They take old beams to refurb, but wouldn't be able to with a bent beam would they?
Depends if its actually bent, alot of poeple say its a bent beam when its just a stub pin or the inner pin!
If the actualy beam is bent then no.
shanelalor
5th March 2010, 12:49
im not sure if it is actually bent, the O/s rear wheel is just like out of line almost slanted, looks like camber but im not too good with the whole torsion bar set up , so i dont want to get involved in in , i just know i need a new beam !
is it worth while buying a refurbed one from imaxle and getting a local garage to fit it?
thanks for the replys
KrisB
7th March 2010, 13:26
That just sounds like the bearings have collapsed, i suspect you'll need new pins too.
If you need the beam swapped / lowered i'm happy to do this for you. I'm also happy for you to get the beam delivered to me and your old beam collected from me as long as you cover the costs.
Sparco_Tom
7th March 2010, 13:53
As above KrisB is your man for the job. Worth the journey to him
KrisB
7th March 2010, 17:11
Thanks tom.
vBulletin® v3.8.2, Copyright ©2000-2025, Jelsoft Enterprises Ltd.