Fill in exhaust hole

[00emelee]

hi guys, ive just had a twin powerflow system on my mk1 vtr, looks and sounds fantastic, but i have a hole where my old exhaust used to be(standard backbox)...Does any one no the best way to fill the hole over with a smooth effect... cheers

[reedy1]

the best way would be to have not been a tight get and baught a powerflow back box aswell .. but .. the best way to repair a hole in a exaust is to tig weld it .. provided theres no rust, if theres rust ya fucked basically :) if it rusts in one place its not far of rusting somewhere else and its pointless repairing

[paulydixon]

I'm confused, you mean the reccess on the bumper?

Get another bumper and cut a section out that matches, then get and old soldering iron and melt the bit into your bumper, then fill, sand and paint.

[marcusd]

I'm confused, you mean the reccess on the bumper?

Get another bumper and cut a section out that matches, then get and old soldering iron and melt the bit into your bumper, then fill, sand and paint.

surely easier to use new bumper then?

[paulydixon]

Eh? A new bumper will still have a hole

[marcusd]

sorry thought was going from twin to single exhaust

[reedy1]

ah i read the question wrong sorry i get it now .. erm no way i can think of? buy an aftermarket bumper?