removing load sensing valve.

[Gaz_5103]

hi.

going to remove load sensing valve and run new pipes through the cockpit - to the master cylinder.

do i need to fit a brake bias valve? also when running the piping through the firewalls do you just make sure it is not rubbing, or can you get a fitting for fitting copper pipe through firewall?

[adamskiTNR]

You can use grommets or an appropriate bulkhead connector. I'm not sure on what to put in it's place. I would just replace with piping, bias valve are pretty pricey aswell.

[Gaz_5103]

yeh. just want to make sure the back brakes wont lock up all the time if i dont bias the breaking to the front?