View Full Version : want more of a poke what u think??
jack123
28th April 2010, 21:52
i was thinkin about buyin either 32 or 35 spacers to push out the front 2 wheels a bit more would that push it out way to much or would it be fine??
whats your thoughts?
mirrorblanks
28th April 2010, 22:04
depends on what wheels you have already and the offset, and also depends on what you have on the rear
jack123
29th April 2010, 06:39
the off set is 38 so i have 20mm spacers atm but i have 165 streches and i cant move the back anymore or it would rub
CJ2404
29th April 2010, 09:16
Anything 25mm or over needs hub adaptors mate,
think kei racing do a set to fit their alloys iirc
bout 100quid for a set
chrisvtr1989
29th April 2010, 10:38
I personally wouldn't feel safe running 35mm spacers. Be prepared to be changing wheel bearings if you use them
jack123
29th April 2010, 15:38
so whats the most u guys think i should be doing to make them sit out a bit more?
chrisvtr1989
29th April 2010, 15:42
What width are your wheels?
jack123
29th April 2010, 15:44
7j mate
jack123
29th April 2010, 15:48
what if i had 35mm Hubcentric Spacers would that be to much poke or is that what u ment by not feeling safe?
jack123
2nd May 2010, 14:17
what about these or is this just dodgy??
http://cgi.ebay.co.uk/32mm-euro-look-spacers-4-stud-Citroen,saxo,etc_W0QQitemZ300292283899QQcmdZViewIt em?rvr_id=&rvr_id=&cguid=71b5ec801260a0aad215b3a5ffb19cc7#ht_1943wt_8 18
mirrorblanks
2nd May 2010, 14:58
this might be easier for you to understand, using a 32mm spacer on a et38 wheel basically makes the wheel et6 whch is low, but because saxos are around et15 iirc they shouldn't stick out too much but they only problem is because of the spacers you'll probably end up changing wheel bearings quite abit
jack123
2nd May 2010, 15:28
yea that it den al i want to no if how much can i go out?
mirrorblanks
2nd May 2010, 16:10
don't go stupid amounts, remember tyre tread needs to be under the arches
jack123
2nd May 2010, 17:07
yea i no that but i just want it out a little more like 25 or 32
ste-saxo
2nd May 2010, 17:40
i have 35mm spacers on the back, and mine dont stick out the archs running on vtr rims if its any help
mirrorblanks
2nd May 2010, 19:37
i have 35mm spacers on the back, and mine dont stick out the archs running on vtr rims if its any help
vtr rims are 6j iirc
jack123
2nd May 2010, 20:40
mines 7j lol so they will sit past the arch lol i might try 32 or 25
vBulletin® v3.8.2, Copyright ©2000-2025, Jelsoft Enterprises Ltd.