detailing sequence need help???

[VinceVTS]

so im gonna be doing a bigish detail sonn (for me anyway) is this the correct order for me and correct products

1) Jet wash
2) snow foam
3) jet wash
4) chemicle guys bodywash and wax
5) jet wash
6) Bilt hamber clay + dodo juice born slippery
7) jet wash
8) ag srp
9) jet wash
10) dodo juice lime prime
11) chemicle guys wet mirror finish
12) dodo juice banana armour

Extras) bilbery wheels, AG fastglass, chemicle guys new look trim, cockpit cleaner, and some air freshner

Does that sound good to you??

also im gonna be doing under the bonet aswell shall i do all that for under the bonet or just bits of it???

Many thx

Vince

[P90PTS]

I personally don't jet wash before a snow foam, allows the foam to cling for longer.

I would wash after you clay rather than a jet wash. And also after your AG SRP, both times just to ensure you've fully cleared the car of any residue.

What're you using to dry the car?

For the engine bay, have a look at a guide I made buddy! :y:

Paul.

[VinceVTS]

just my huge fluffy drying towel from cyc, cheers for the advice buddy

[James106]

Get some Poorboys all in one polish bit better than AG SRP :)

[VinceVTS]

yeah i know lol but i go loads of srp polish so want to use it up lol, am trying to save money for fcs

[James106]

Fair enough Vince!

See you on the 12th!

[CHIP]

SRP will do you if you've got plenty of it. It isn't awful stuff, it's got a quite a lot of filling properties from what i've read and is fairly decent at covering up swirls...

Not to say that your swirls will be gone though. But one chap on DW acheived fairly decent swirl removal with it by hand but it was a lot of hard work... Probably not worth it tbh lol.

[VinceVTS]

yeah i know bud i really dont want to use it but i cant waste it lol, im one of those people where if i can somthing 30p cheaper im allready there lol, so wasting 2 btls or srp and a 500ml bottle is somthing i could not so, was looking at getting some chemicle guys all in 1 polish or the poorboys super swirl remover 2.5

[CHIP]

SSR2.5 is very hard to apply and remove imo. It also needs other polishes to go with it ideally. Not just using it on it's own.

I've got plenty of spare SRP and use it on my wheels. Then seal it with FK1000P (used that for the first time last night, very happy with it, something for you to consider in the future :) )

[VinceVTS]

so maybe chemicle guys all in 1 polish