quick qestion

[1-1dicky]

after lowering my torsion bar and it being too low i raised it back up, now i want to lower it again but dont want to do what i did last time and have it lower one side than the other. other than using a tape mesure what can i use that will make sure both sides are exacly the same?

thanks

[laberridge]

not much you can do really, just mark where your measure from, and make sure you do it at same point on otherside

[1-1dicky]

ahhh, i thought there may have been a better way?

[laberridge]

ahhh, i thought there may have been a better way?

laser tape mesure?