Buckets Seats into 106 gti seats, urgent HELP please :)

[AJ-VTR]

hi all,

Currently have some corbeau forza buckets seats but getting some 106gti seats. Questions i have are :

are these seats easy to fit?

what adjustments would i need to make if any?

i have standard rear vtr seats, obviously 106 rear seats split in two (down the middle) whereas vtr seats are just one piece, are these still straight fitment? If not, what adjustments would i need to make?


Thanks for your help

[DusheR]

They use the same mounting points as standard saxo seat (assuming you have a saxo). So yes they are easy to fit.

Cant think of any adjustments.

The rear bench has a hinge on the bottom where it splits. You can bolt this in position in the saxo or I just left it wedged behind the bench as I didnt have the bolts/nuts. (cant remember if theres studs or just tapped holes for bolts)

[AJ-VTR]

thanks DusheR :)

[AJ-VTR]

just had a look and my buckets do NOT have the standard saxo frames attached to the bottom, however with the 106gti seats i am looking to buy, they come with the rails on the bottom, are these frames suitable to fit into a saxo?

Cheers

[Joe]

yea mate im pretty sure they fit straight in

[Mochachino]

the 106 and saxo are the same car..106 seats and saxo seats are the same.

[AJ-VTR]

thanks everyone :) and are the rear seats the same fitment as a 106 too :)

[Mochachino]

Yes they are, you just need to bolt in the middle metal clip bit with an 8mm or 10mm. Thats it!