PDA

View Full Version : Cutting numberplates down...

Elliott
3rd February 2011, 00:24
What do you use to cut them down?

What type of saw?
Matto
3rd February 2011, 00:29
Err... the cutting type...





Little hacksaw should do it and some sandpaper to smooth bits.
haz_pro
3rd February 2011, 00:29
I use a butter knife.
J222JRA
3rd February 2011, 00:31
Fine tooth tennon saw would be fine.
langy88
3rd February 2011, 00:32
I think it's illegal mate because you will end up cutting the E mark off. Which I think would makes it illegal.

I'm sure I read this on here once but don't quote me on it
timmythechef
3rd February 2011, 00:35
tile cutters some people use
Viper
3rd February 2011, 00:38
Scissors
Dave_P
3rd February 2011, 06:43
Keep a 11mm minimum gap between edge & letters as well as BS number to keep it legal.
W103_A5H
3rd February 2011, 07:37
Stanley knife
RustySkull
3rd February 2011, 07:44
Hmm, I've never heard of this before lol.

Or seen it... What does it look like? Any good?
Peter_D
3rd February 2011, 07:55
I think it's illegal mate because you will end up cutting the E mark off. Which I think would makes it illegal.

I'm sure I read this on here once but don't quote me on it

Just had to quote you since you said not to, rebel