306 interior in a saxo?...

[JohnnyNiicholass]

anyone know if id be able to fit full 306 interior into my 1.1 saxo? :D, i know it may be a tight squeeze but would it be possible...

[JohnnyNiicholass]

anyone?...

[saxo_singh]

I think the front seats will fit, just the back ones might need the brackets were they bolt onto cut and welded to fit the 306 back seats.

[JohnnyNiicholass]

yeah i thinking the same, i know the front seats should fit, but what if i take the 306 rear seats off the brackets, and put when onto the brackets in my saxo, would that work... :S

[saxo_singh]

Could work, you will need to do a few measurements, and then weld them on. And hope your measurements were precise! lol

[JohnnyNiicholass]

im a plumber, my job depends on precise measurements haha :), thanks mate :D

[baker556]

the rears are a pain in the ass tbh, not worth it do the front and get 106 rear.

The front is a straight fit but they sit lower on the left side and need washers in between the bolts to bring them up otherwise they rub on the carpet. The left hand side would have to be adjusted somehow to raise it up to get it level.

[JohnnyNiicholass]

the front seats aint a problem i can get them to fit, its just the rears, i have a full 306 gti-6 interior, and was just wondering if i could get this interior to fit, saves spending more money on 106 rear seats, even though its only a few quid lol