pug leather into vtr

[gerrysax]

i was wondering if pug gti 106 leather seats would fit into my mkii vtr and ifso wats the deal with the cable going into the arse of my two front seats

[Graeme]

yes it would fit

the orange wire is you seatbelt tenser wire

[ChrisJ]

yes it would fit

the orange wire is you seatbelt tenser wire

That will be the seatbelt TENSIONERS then smileys/smiley2.gif

[Graeme]

yes it would fit

the orange wire is you seatbelt tenser wire

That will be the seatbelt TENSIONERS then smileys/smiley2.gif

thats the one i was on a call to a cust at the time matey smileys/smiley17.gif smileys/smiley9.gif

[ChrisJ]

smileys/smiley12.gif

[Graeme]

smileys/smiley12.gif

what the fooks that smiley for? smileys/smiley5.gif

[ChrisJ]

for you makin excuses lol smileys/smiley17.gif

[furioAL]

wats the deal with the cable going into the arse of my two front seats


Using a small torx screwdriver undo the screw in the plasic side of the seat (same side as the buckle). Once undone you should be able to lift up the side casing from around the buckle and remove it. Then you remove the silver clip connecting the orange cable to the pretensioner and then unplug the pretensioner itself.

Then using a larger torx bit undo the four bolts that hold the seat runners down. The seat should then come straight out smileys/smiley14.gif then it is just a simple swap with the pug one! and do the reverse to fit the new one...

Once installed turn your ignition on and check the "airbag warning light" doesn't come on... if it does you have not connected your seat belt pretensioners correctly...

Hope that helps
Alex
smileys/afro.gif

[gerrysax]

cheers furioAl ill take that on board my manmuch appreciated