rear washer removal

[Wile0ut]

had a go at it earlir when i finished work but dont know how to get tfe f@cker out

this is where im at

http://i987.photobucket.com/albums/ae358/dan_t_photos/Photo0458.jpg

any tips would be appreciated

Dan:y:

[OGGY-VTR]

right next u have to remove the jet by using a pair of plyers to press in the lil plastic prongs then it will pull out, then weld up the hole and then fill and spray, dun

[Wile0ut]

pop out the top yh?

[danny-vts]

yes will come out from the top m8

[langy88]

How are you covering the hole mate? Because my rear washer spent work but I don't want to cover it with a grommet because its not flush

[Wile0ut]

just used a grommet for now its pretty flat. looks better than the washer jet

[stevo67]

I siliconed a grommet in mine fine so far,then put a bolt with siicone around the thread then wound it in the washer pipe.

[Wile0ut]

ooooh yh forgot about the pipe il bung that up tommorow

[Jamescl1992]

I siliconed a grommet in mine fine so far,then put a bolt with siicone around the thread then wound it in the washer pipe.

What size grommet did you use cause im looking to take mine out

[stevo67]

I just bought a pack of mixed grommets from Halfrauds mate,& found 1 in there to fit.


Steve.