-Dan-
30th March 2011, 16:16
Seen this asked a few times on here, most likely by people that happen to be using the same diagnostic software/cable (in my case it was Elm 327 and ProScan)
It'll come up with a fault under Pending trouble codes for:
"P0711 - Transmission Fluid Temperature Sensor Circuit Range/Performance"
After searching around Google for quite a while I found that this code is activated when:
The Engine Control Module (ECM) detected engine temperature change but recorded no transmission temp change.
Since the Saxo has no Transmission Fluid Temperature Sensor, it is quite likely that yes, the software is finding an engine temp change without a transmission temp change, so my guess is that it's nothing to worry about.
It'll come up with a fault under Pending trouble codes for:
"P0711 - Transmission Fluid Temperature Sensor Circuit Range/Performance"
After searching around Google for quite a while I found that this code is activated when:
The Engine Control Module (ECM) detected engine temperature change but recorded no transmission temp change.
Since the Saxo has no Transmission Fluid Temperature Sensor, it is quite likely that yes, the software is finding an engine temp change without a transmission temp change, so my guess is that it's nothing to worry about.