hi have a problem help please

[nathanb82]

:sad:hi everyone im new to this so trying to get my posts up lol, had a problem today park my car up and pulled my handbrake up and pop, i think i have snaped my handbrake cable if anyone could help me on how to change it i will be greatful. thanks

[danny-vts]

from the end of the downpipe to the back, take your exhaust off, remove heat shields.
there will be 2 bolt type adjusters on the cables, loosen them off until you can take the cables out, then remove the cables from the rear . job done
when putting new cables in, start from rear and work your way up to the middle,

[Furio-Gazza]

from the end of the downpipe to the back, take your exhaust off, remove heat shields.
there will be 2 bolt type adjusters on the cables, loosen them off until you can take the cables out, then remove the cables from the rear . job done
when putting new cables in, start from rear and work your way up to the middle,

Ive got to do this to mine and tbh sounds a right pain to do :n:

[danny-vts]

it sounds harder than it is, i had to change mine when i did rear axle.
not that hard at all

[bigdog]

tis an easy diy job,,worst bit is if cables are seized in caliper be care full taking out or you will end up buying calipers to as alloy will break away around cable