Bent metal At Front ?

[wallisidesign]

just a quick question this was my car befor i crashed it...

http://img594.imageshack.us/img594/6407/vt1g.jpg

i was woundering what are the names of these parts , and where can i gt new ones ? and is it a case of cutting the old ones out and welding the new one ???? thanks all advice welcome

http://img195.imageshack.us/img195/996/vt20.jpg

[saxo-parts]

bottom crossmember and chassis leg end plates from dealers, front edges of inner wings just need pulling out rather then replacing. Check the chassis legs further back though as a slight knock can bend them as well

[wallisidesign]

thanks mate

[Paul]

As said you should be more worried about the passenger chassis leg being bent.