PDA

View Full Version : washer jests dont work


mysaxovtr
2nd October 2011, 12:06
for some strange reason my washer jets dont work its been filled up with water and when i hold them on the wipers work but no fluid comes out..

any 1 have any ideas how to fix this

thanks

danny-vts
2nd October 2011, 12:23
can you hear the pump when you pull the stalk?
if not: check to see if fuse has blown, if it hasnt you may need a new washer bottle pump (few quid from a scrappies).
if you can hear the pump, you may have blocked jets, poke the jets with a sewing needle.

jonnyb2b
2nd October 2011, 12:36
Exactly wat Danny-vts said!!

Jon

Robbie-Flat-Arch
2nd October 2011, 12:39
yeh i had this on my last car took the little pipe off the bottom of the jets and it was full of shit left the pipe off pushed the button again and cleaned it all out then put them back on :)

mysaxovtr
3rd October 2011, 19:03
Hi guys I can here the pumps so what I did was disconnect the rubber from the jets and there's nothing coming through the bottle hasn't leaked so what should I do no? Cheers

mcjacko1987
3rd October 2011, 19:16
disconnect the rubber from the pump. see if liquid comes out of the pump itself. if so then the pipes need replacing. could be blocked or split somewhere else.

is fluid coming out of the tank when u use the washers? like how it would if they where working?

stevo67
3rd October 2011, 19:31
If you have access to a compressor then a blast of air through the tubing sometimes works.

iFurio
4th October 2011, 21:08
Mine do not work either :( I can hear the sound when you pull the leaver :L Ill have to try some the suggestions, most prob just blocked somewhere :(