Side skirt

[Blair-16]

Absolutly stumped! haha! Well literally studied the thread on putting a vts kit on a 1.1, but how the heck you fit the side skirts on I know the bit about how you have to drill holes for the clips, but where do the little hook type clips go or fit on?

If anyone understood that would appreciate the help cheeers!

[Bedford126]

The L shaped clips need to be bonded to the bottom lip of the sill the vt's come with little metal pins that they snap onto but you can just bond them in place. Best bet is to put a dab of paint on the back of them and fit the sill dry the paint spots will transfer to the sill and show you where to bond them to. Tiger seal will be more than enough to hold them in place.

[Blair-16]

Aw mate class Thats exactly what a was looking for cheers mate haha! And see the other clips you drill them eh?

[Bedford126]

Yeah mate use masking tape to measure the holes and mark them then use a punch to stop the drill skipping about and also touch up the bare metal with paint /under seal and get some wax oil in the sills whilst you have access through the holes you drilled to prevent rust.

[Blair-16]

Aw cheers mate mate thought that bud well got most of the kit done just got side skirts to put on so try and get that done cheers for the help bud